<ul id="e0qw2"></ul>

<fieldset id="e0qw2"></fieldset>

<strike id="e0qw2"></strike>

<ul id="e0qw2"></ul>

<tfoot id="e0qw2"></tfoot>

<fieldset id="e0qw2"></fieldset>

<abbr id="e0qw2"></abbr>

<fieldset id="e0qw2"></fieldset>

返回提問

ASP連接access數據庫例程

發布時間:2006-04-18 22:57:40 瀏覽人數: 772279 次

關鍵字: access數據庫 - 本站搜索 - Google搜索 - Baidu搜索 - Yahoo搜索 - sougo搜索

ASP連接access數據庫例程

注意：要運行上述ACCESS例程請先下載數據庫，放在db 或 rwdata文件夾下。請將例程放在根目錄下。
<%
Dim mode
mode=request.form("text4")
if mode=1 then
name=request.form("text1")
age=request.form("text2")
addr=request.form("text3")
if not isnumeric(age) then response.write "age must be number!try again":response.end
age=clng(age)
end if '********************************************************************
' 與AccessDB相關的連接信息
' 可以參照它建立您的數據庫連接
'********************************************************************
Dim conn,rs,dbpath
Set conn=Server.CreateObject("ADODB.Connection")
Set rs=Server.CreateObject("ADODB.RecordSet")
dbpath=Server.MapPath("rwdata/db_test_com.mdb")
conn.Open "Driver={Microsoft Access Driver (*.mdb)}; DBQ="&dbpath
'********************************************************************
'********************************************************************

dim strsql
'********************************************************************
' 讀數據庫相關操作
sub readdb()
strsql="select * from test"
rs.open strsql,conn,1,1
if rs.EOF then response.write "no record at all":exit sub
response.write "

"
response.write ""
for i=0 to rs.Fields.Count-1
response.write ""
next
response.write ""
while not rs.EOF
response.write ""
for i=0 to rs.Fields.Count-1
response.write ""
next
response.write ""
rs.MoveNext
wend
response.write "

"&rs.Fields(i).Name&"

"&rs.Fields(i).Value&"

"
rs.Close
end sub
'********************************************************************

'********************************************************************
' 寫數據庫相關
sub insertdata()
strsql="INSERT INTO test(name,age,addr) VALUES('"&name&"',"&age&",'"&addr&"')"
rs.Open strsql,conn,1,3
end sub
'********************************************************************

if mode=1 then
call insertdata()
response.write "insert ok!"
elseif mode=2 then
call readdb()
end if

'********************************************************************
' 釋放數據庫連接對象
set rs=nothing
set conn=nothing
%>